Virtual Private Routed Network Services
7750 SR OS Services Guide Page 1193
Values be, ef, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cp9, cs1, cs2, cs3, cs4, cs5, nc1, nc2, af11,
af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, cp11, cp13, cp15,
cp17, cp19, cp21, cp23, cp25, cp27, cp29, cp31, cp33, cp35, cp37, cp39, cp41,
cp42, cp43, cp44, cp45, cp47, cp49, cp50, cp51, cp52, cp53, cp54, cp55, cp57,
cp58, cp59, cp60, cp61, cp62, cp63
fc fc-name — Specifies the forwarding class name. All packets with DSCP value or MPLS EXP bits
that is not defined will be placed in this forwarding class.
Default None, the fc name must be specified
Values be, l2, af, l1, h2, ef, h1, nc
single-sfm-overload
Syntax single-sfm-overload [holdoff-time holdoff-time]
no single-sfm-overload
Context config>service>vprn
Description This command, if enabled, will cause the IGP protocols (either IS-IS or OSPF) for the service to enter
an overload state when the node only has a single SFM functioning.
The no form of this command causes the overload state to be cleared.
Default no single-sfm-overload
Parameters holdoff-time — This parameter specifies the delay between the detection of a single SFM and
enacting the overload state.
Values 1—600 seconds
Default 0 seconds
snmp-community
Syntax snmp-community community-name [version SNMP-version]
no snmp-community [community-name]
Context config>service>vprn
Description This command sets the SNMP community name to be used with the associated VPRN instance.
If an SNMP community name is not specified, then SNMP access is not allowed.
The no form of the command removes the SNMP community name from the given VPRN context.
Default None — The SNMP community must be explicitly specified.
Parameters community-name — Specifies one or more SNMP community names.
version SNMP-version — Specifies the SNMP version.
Values v1, v2c, both
To Next Page
Loading...
