VPRN Service Configuration Commands
Page 1226 7750 SR OS Services Guide
intersite-shared
Syntax intersite-shared
no intersite-shared
Context config>service>vprn>mvpn
Description This command specifies whether to use inter-site shared C-trees or not.
Default intersite-shared
provider-tunnel
Syntax provider-tunnel
Context config>service>vprn>mvpn
Description This command enables context to configure tunnel parameters for the MVPN.
inclusive
Syntax inclusive
Context config>service>vprn>mvpn>pt
Description This command enables the context for specifying inclusive provider tunnels
pim
Syntax pim {asm | ssm} grp-ip-address
no pim
Context config>service>vprn>mvpn>pt>inclusive
Description This command specifies the PIM mode to use, ASM or SSM, for PIM-based inclusive provider
tunnels and the multicast group address to use. Also enables the context for specifying parameters for
PIM peering on the inclusive provider tunnel.
Note that auto-discovery must be enabled in order for SSM to operate.
The no form of the command removes the pim context including the statements under the context.
Default no pim
Parameters asm — Specifies to use PIM ASM for inclusive provider tunnels.
ssm — Specifies to u PIM SSM for inclusive provider tunnels.
group-address — Specifies the multicast group address to use.
To Next Page
Loading...
