Virtual Private Routed Network Services
7750 SR OS Services Guide Page 1229
data-delay-interval
Syntax data-delay-interval value
no data-delay-interval
Context config>service>vprn>mvpn>provider-tunnel>selective
Description This command specifies the interval, in seconds, before a PE router connected to the source switches
traffic from the inclusive provider tunnel to the selective provider tunnel.
The no form of the command reverts the value to the default.
Default 3 seconds
Parameters value — Specifies the data delay interval, in seconds.
Values 3 — 180
data-threshold
Syntax data-threshold {c-grp-ip-addr/mask | c-grp-ip-addr netmask} s-pmsi-threshold
no data-threshold {c-grp-ip-addr/mask | c-grp-ip-addr netmask}
Context config>service>vprn>mvpn>provider-tunnel>selective
Description This command specifies the data rate threshold that triggers the switch from the inclusive provider
tunnel to the selective provider tunnel for C-(S,G) within the group range. Multiple statements are
allowed in the configuration.
The no form of the command removes the values from the configuration.
Default none
Parameters group-address/mask — Specifies a multicast group address and netmask length.
rate-threshold — Specifies the rate, in kilobits per second (kbps). If the rate for a C-(S,G) within the
specified group range exceeds the threshold, traffic for the C-(S,G) will be switched to the
selective provider tunnel.
join-tlv-packing-disable
Syntax [no] join-tlv-packing-disable
Context config>service>vprn>mvpn>provider-tunnel>selective>pim
Description This command enables packing of MDT join TLVs into a single PDU to improve efficiency, if
multiple Join TLVs are available at the time of transmission.
The no form of the command disables packing of MDT join TLVs into a single PDU.
Default no join-tlv-packing-disable
To Next Page
Loading...
