VPRN Service Configuration Commands
Page 1230 7750 SR OS Services Guide
pim-ssm
Syntax pim-ssm {grp-ip-address/mask | grp-ip-address netmask}
no pim-ssm
Context config>service>vprn>mvpn>provider-tunnel>selective
Description This command specifies the PIM SSM groups to use for the selective provider tunnel.
Parameters group-address/mask — Specifies a multicast group address and netmask length.
umh-selection
Syntax umh-selection highest-ip | hash-based
no umh-selection
Context config>service>vprn>mvpn
Description This command specifies which UMH selection mechanism to use, highest IP address or hash based.
The no form of the command resets it back to default.
Default umh-selection highest-ip
vrf-export
Syntax vrf-export {unicast | policy-name [policy-name...(up to 5 max)]}
no vrf-export
Context config>service>vprn>mvpn
Description This command specifies the export policy (up to 5) to control MVPN routes exported from the local
VRF to other VRFs on the same or remote PE routers.
Default vrf-export unicast
Parameters unicast — Specifies to use unicast VRF export policy for the MVPN.
policy — Specifies a route policy name.
vrf-import
Syntax vrf-import {unicast | policy-name [policy-name...(up to 5 max)]}
no vrf-import
Context config>service>vprn>mvpn
Description This command specifies the import policy (up to 5) to control MVPN routes imported to the local
VRF from other VRFs on the same or remote PE routers.
Default vrf-import unicast
To Next Page
Loading...
