Alcatel-Lucent 7750 SR - Page 1310

VPRN Service Configuration Commands
Page 1310 7750 SR OS Services Guide
slope-policy
Syntax slope-policy hsmda-slope-policy-name
no slope-policy
Context config>service>vprn>if>sap>egress>hsmda-queue-overider
config>service>vprn>if>sap>ingress>hsmda-queue-overider
Description This command specifies an existing slope policy name.
secondary-shaper
secondary-shaper secondary-shaper-name
no secondary-shaper
Context config>service>vprn>if>sap>egress>hsmda-queue-overider
Description This command configures an HSMDA secondary shaper. Note that an shaper override can only be
configured on an HSMDA SAP.
Parameters secondary-shaper-name — Specifies a secondary shaper name up to 32 characters in length.
match-qinq-dot1p
Syntax match-qinq-dot1p {top | bottom}
no match-qinq-dot1p
Context config>service>vprn>if>sap>ingress
config>service>vprn>sub-if>grp-if>sap>ingress
config>service>vprn>ipsec-if>sap>ingress
Description This command specifies which Dot1Q tag position Dot1P bits in a QinQ encapsulated packet should
be used to evaluate Dot1P QoS classification.
The match-qinq-dot1p command allows the top or bottom PBits to be used when evaluating the
applied sap-ingress QoS policy’s Dot1P entries. The top and bottom keywords specify which
position should be evaluated for QinQ encapsulated packets.
The no form of the command restores the default dot1p evaluation behavior for the SAP.
By default, the bottom most service delineating Dot1Q tags Dot1P bits are used. The following table
defines the default behavior for Dot1P evaluation when the match-qinq-dot1p command is not
executed.
Port / SAP Type Existing Packet Tags PBits Used for Match
Null None None
Null Dot1P (VLAN-ID 0) Dot1P PBits
Null Dot1Q Dot1Q PBits