Page 140 7750 SR OS Services Guide
Description This command renumbers existing MRP policy entries to properly sequence policy entries. This may
be required in some cases since the implementation exits when the first match is found and executes
the actions according to the accompanying action command. This requires that entries be sequenced
correctly from most to least explicit.
Parameters old-entry-id — Specifies the entry number of an existing entry.
Values 1-65535
new-entry-id — Specifies the new entry number to be assigned to the old entry. If the new entry
exists, an error message is generated.
assignment
Syntax assignment {port port-id | card slot-number}
no assignment
Context config>service>customer>multi-service-site
Description This command assigns a multi-service customer site to a specific chassis slot, port, or channel. This
allows the system to allocate the resources necessary to create the virtual schedulers defined in the
ingress and egress scheduler policies as they are specified. This also verifies that each SAP assigned
to the site exists within the context of the proper customer ID and that the SAP was configured on the
proper slot, port, or channel. The assignment must be given prior to any SAP associations with the
site.
The no form of the command removes the port, channel, or slot assignment. If the customer site has
not yet been assigned, the command has no effect and returns without any warnings or messages.
Default None
Parameters port port-id — The port keyword is used to assign the multi-service customer site to the port-id or
port-id.channel-id given. When the multi-service customer site has been assigned to a specific
port or channel, all SAPs associated with this customer site must be on a service owned by the
customer and created on the defined port or channel. The defined port or channelmust already
have been pre-provisioned on the system but need not be installed when the customer site
assignment is made.
Syntax: port-id[:encap-val]
Values port-id slot/mda/port[.channel]
aps-id aps-group-id[.channel]
aps keyword
group-id 1 — 64
bundle-type-slot/mda.bundle-num
bundle keyword
type ima, ppp
bundle-num 1 — 256
bpgrp-id: bpgrp-type-bpgrp-num
bpgrp keyword
type ima
bpgrp-num 1 — 1280
ccag-id - ccag
-<id>.<path-id>[cc-type]
To Next Page
Loading...
