Page 148 7750 SR OS Services Guide
for an existing sdp-id, an error is generated and the context of the CLI will not be changed to the
specified sdp-id.
The no form of this command deletes the specified SDP. Before an SDP can be deleted, it must be
administratively down (shutdown) and not bound to any services. If the specified SDP is bound to a
service, the no sdp command will fail generating an error message specifying the first bound service
found during the deletion process. If the specified sdp-id does not exist an error will be generated.
Default none
Parameters sdp-id — The SDP identifier.
Values 1 — 17407
gre — Specifies the SDP will use GRE to reach the far-end 7750 SR. Only one GRE SDP can be
created to a given destination device. Multiple GRE SDPs to a single destination serve no
purpose as the path taken to reach the far end is determined by the IGP which will be the same for
all SDPs to a given destination and there is no bandwidth reservation in GRE tunnels.
mpls — Specifies the SDP will use MPLS encapsulation and one or more LSP tunnels to reach the
far-end device. Multiple MPLS SDPs may be created to a given destination device . Multiple
MPLS SDPs to a single destination device are helpful when they use divergent paths.
accounting-policy
Syntax accounting-policy acct-policy-id
no accounting-policy
Context config>service>pw-template
config>service>sdp
Description This command creates the accounting policy context that can be applied to an SDP. An accounting
policy must be defined before it can be associated with a SDP. If the policy-id does not exist, an error
message is generated.
A maximum of one accounting policy can be associated with a SDP at one time. Accounting policies
are configured in the config>log context.
The no form of this command removes the accounting policy association from the SDP, and the
acccounting policy reverts to the default.
Default Default accounting policy.
Parameters acct-policy-id — Enter the accounting policy-id as configured in the config>log>accounting-policy
context.
Values 1 — 99
bgp-tunnel
Syntax [no] bgp-tunnel
Context config>service>sdp
To Next Page
Loading...
