Subscriber Services
7750 SR OS Services Guide Page 149
Description This command allows the use of BGP route tunnels available in the tunnel table to reach SDP far-end
nodes. Use of BGP route tunnels are only available with MPLS-SDP. Only one of the transport
methods is allowed per SDP - LDP, RSVP-LSP or BGP-Tunnel (BGP-Tunnel is not supported on
multi-mode LSP)
The no form of the command disables resolving BGP route tunnel LSP for SDP far-end.
Default no bgp-tunnel (BGP tunnel route to SDP far-end is disabled)
booking-factor
Syntax booking-factor percentage
no booking-factor
Context config>service>sdp
Description This command specifies the booking factor applied against the maximum SDP available bandwidth
by the VLL CAC feature.
The service manager keeps track of the available bandwidth for each SDP. The maximum value is the
sum of the bandwidths of all constituent LSPs in the SDP. The SDP available bandwidth is adjusted
by the user configured booking factor. A value of 0 means no VLL can be admitted into the SDP.
The no form of the command reverts to the default value.
Parameters percentage — Specifies the percentage of the SDP maximum available bandwidth for VLL call
admission. When the value of this parameter is set to zero (0), no new VLL spoke SDP bindings
with non-zero bandwidth are permitted with this SDP. Overbooking, >100% is allowed.
Values 0 — 1000 %
Default 100%
collect-stats
Syntax [no] collect-stats
Context config>service>pw-template
config>service>sdp
Description This command enables accounting and statistical data collection for either the SDP. When applying
accounting policies the data, by default, is collected in the appropriate records and written to the
designated billing file.
When the no collect-stats command is issued the statistics are still accumulated by the IOM cards.
However, the CPU will not obtain the results and write them to the billing file. If a subsequent
collect-stats command is issued then the counters written to the billing file include all the traffic
while the no collect-stats command was in effect.
Default collect-stats
To Next Page
Loading...
