Versatile Service Module
7750 SR OS Services Guide Page 1487
sap
VPLS SAP
Syntax sap ccag-ccag-id.{a | b}[.sap-net | .sap-sap]:cc-id [create]
no sap ccag-ccag-id.{a | b}[.sap-net | .sap-sap]:cc-id
Context config>service>vpls
Description This command creates a cross connect SAP on the ccag-id referenced in the VPLS service. A CCAG
SAP is identified by four items; the ccag-id, the CCAG path, the pairing type and the cc-id. A VPLS
CCAG SAP supports all the available QoS, filtering and accounting features as a VPLS Dot1Q SAP.
The no form of the command removes a SAP from a service context. Once removed, all information
and resources concerning the SAP is deleted from the system including the CCAG cc-id in use on the
CCA path.
Parameters ccag — The ccag portion of the SAP identifier is required and specifies that the vpls SAP is of the
CCAG type.
-ccag-id — Specifies which ccag-id on which the SAP must be created. The specified ccag-id must
exist on the system or the SAP creation will fail. The leading dash must be included as a
separator between ccag and the ccag-id.
Values -1 (dash 1) to -8 (dash 8)
Default None
.a | .b — The .a and .b portion of the CCAG SAP identifier is required and is used to define the CCA
bandwidth path with will be associated with the SAP. The path association must be specified and
.a and .b are mutually exclusive. The .a designation identifies the SAP as being on the Alpha path
and the .b designation identifies the SAP as being on the Beta path. The paired SAP or network
IP interface using the same cc-id as the SAP must be associated with the opposite path. The
leading period must be included as a separator between the ccag-id and the path designator.
Values .a or .b
Default None
.sap-net — The .sap-net portion of the CCAG SAP identifier specifies that the SAP is of the SAP-2-
Net pairing type and is required when the cc-id is paired with a network IP interface. The pairing
type .sap-net is mutually exclusive with pairing type .sap-sap. If .sap-net is not specified, .sap-sap
is assumed and does not need to be included in the SAP identification. When specified, the
leading period must be used as a separator between the path designator and the pairing type.
Values .sap-net or .sap-sap
Default .sap-sap
.sap-sap — The .sap-sap portion of the CCAG SAP identifier is mutually exclusive to .sap-sap and is
used to define the pairing type as SAP-2-SAP. The .sap-sap pairing type is only used when the
cross connect object sharing the same cc-id on the opposite path is a CCAG SAP. If the other
cross connect object is a network IP interface, the pairing type must be defined as .sap-net. If
.sap-net is not specified, .sap-sap is assumed and does not need to be included in the SAP
identification. When specified, the leading period must be used as a separator between the path
designator and the pairing type.
To Next Page
Loading...
