VLL Show Commands
7750 SR OS Services Guide Page 1551
base
Syntax base
Context show>service>id
Description Displays basic information about the service ID including service type, description, SAPs and SDPs.
Output Show Service-ID Base — The following table describes show service-id base output fields:
Label Description
Service Id
The service identifier.
Vpn Id
Specifies the VPN ID assigned to the service.
Service Type
The type of service: Epipe, Apipe, Fpipe, Ipipe, VPLS, IES, VPRN.
Description
Generic information about the service.
Customer Id
The customer identifier.
Last Mgmt Change
The date and time of the most recent management-initiated change to
this customer.
Adm
The desired state of the service.
Oper
The operating state of the service.
Mtu
The largest frame size (in octets) that the service can handle.
Def. Mesh VC Id
This object is only valid in services that accept mesh SDP bindings. It
is used to validate the VC ID portion of each mesh SDP binding
defined in the service.
SAP Count
The number of SAPs defined on the service.
SDP Bind Count
The number of SDPs bound to the service.
Identifier
Specifies the service access (SAP) and destination (SDP) points.
Type
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
AdmMTU
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end ESR, without requiring the
packet to be fragmented.
PBB Tunnel Point
Specifies the endpoint in the B-VPLS environment where the Epipe
terminates.
Admin MTU
Specifies the B-VPLS admin MTU.
Backbone-Flooding
Specifies whether or not the traffic is flooded in the B-VPLS for the
detination instead of unicast. If the backbone destination MAC is in the
B-VPLS FDB, then it will be unicast.
To Next Page
Loading...
