Alcatel-Lucent 7750 SR - Page 1552

Show, Clear, Debug Commands
Page 1552 7750 SR OS Services Guide
Sample Output
*A:ALA-48>config>service>epipe>sap# show service id 6 base
===============================================================================
Service Basic Information
===============================================================================
Service Id : 6 Vpn Id : 6
Service Type : Epipe
Description : Distributed Epipe service to east coast
Customer Id : 6
Last Status Change: 02/02/2009 09:27:55
Last Mgmt Change : 02/02/2009 09:27:57
Admin State : Up Oper State : Down
MTU : 1514
Vc Switching : False
SAP Count : 1 SDP Bind Count : 1
-------------------------------------------------------------------------------
Service Access & Destination Points
-------------------------------------------------------------------------------
Identifier Type AdmMTU OprMTU Adm Opr
-------------------------------------------------------------------------------
sap:1/2/9:0 q-tag 1518 1518 Up Down
sdp:2:6 S(10.10.10.104) n/a 0 0 Up Down
===============================================================================
*A:ALA-48>config>service>epipe>sap#
endpoint
Syntax endpoint [endpoint-name]
Context show>service>id
Description This command displays service endpoint information.
Parameters endpoint-name — Specifies the name of an existing endpoint for the service.
Sample Output
*A:ALA-48>config>service>epipe# show service id 6 endpoint
===============================================================================
Service 6 endpoints
===============================================================================
Endpoint name : x
Revert time : 0
Act Hold Delay : 0
Tx Active : none
-------------------------------------------------------------------------------
Members
ISID
The 24 bit field carrying the service instance identifier associated with
the frame. It is used at the destination PE as a demultiplexor field.
Label Description (Continued)