Show, Clear, Debug Commands
Page 1634 7750 SR OS Services Guide
A:Dut-C# show service egress-multicast-group emg1
===============================================================================
Egress Multicast Group Entry
===============================================================================
Group : emg1
-------------------------------------------------------------------------------
Chain Limit : 16 Encap Type : dot1q
Dot1q ether type : 0x8100 Filter-Id : n/a
-------------------------------------------------------------------------------
Service Access Points
1/1/1:100
===============================================================================
A:Dut-C#
gsmp
Syntax gsmp
Context show>service>id
Description This command displays GSMP information.
neighbors
Syntax neighbors group [name] [ip-address]
Context show>service>id>gsmp
Description This command displays GSMP neighbor information.
Parameters group — A GSMP group defines a set of GSMP neighbors which have the same properties.
name — Specifies a GSMP group name is unique only within the scope of the service in which it is
defined.
ip-address — Specifies the ip-address of the neighbor.
Sample Output
These commands show the configured neighbors per service, regardless of the fact there exists an
open TCP connection with this neighbor. The admin state is shown because for a neighbor to be
admin enabled, the service, gsmp node, group node and the neighbor node in this service must all be
in 'no shutdown' state. Session gives the number of session (open TCP connections) for each
configured neighbor.
A:active>show>service>id>gsmp# neighbors
============================================================================
GSMP neighbors
============================================================================
Group Neighbor AdminState Sessions
----------------------------------------------------------------------------
dslam1 192.168.1.2 Enabled 0
dslam1 192.168.1.3 Enabled 0
----------------------------------------------------------------------------