Alcatel-Lucent 7750 SR - Page 1701

VPLS Show Commands
7750 SR OS Services Guide Page 1701
Show Multi-Chassis Endpoint Commands
endpoint
Syntax endpoint [endpoint-name]
Context show>service>id
Description This command displays service endpoint information.
Parameters endpoint-name — Specifies an endpoint name created in the config>service>vpls context.
Sample Output
*A:Dut-B# show service id 1 endpoint
===============================================================================
Service 1 endpoints
===============================================================================
Endpoint name : mcep-t1
Description : (Not Specified)
Revert time : 0
Act Hold Delay : 0
Ignore Standby Signaling : false
Suppress Standby Signaling : false
Block On Mesh Fail : true
Multi-Chassis Endpoint : 1
MC Endpoint Peer Addr : 3.1.1.3
Psv Mode Active : No
Tx Active : 231:1
Tx Active Up Time : 0d 00:06:57
Revert Time Count Down : N/A
Tx Active Change Count : 5
Last Tx Active Change : 02/13/2009 22:08:33
-------------------------------------------------------------------------------
Members
-------------------------------------------------------------------------------
Spoke-sdp: 221:1 Prec:1 Oper Status: Up
Spoke-sdp: 231:1 Prec:2 Oper Status: Up
===============================================================================
*A:Dut-B#