Show, Clear, Debug Commands
Page 1712 7750 SR OS Services Guide
Description Clears all spanning tree statistics for the service ID.
detected-protocols
Syntax detected-protocols {all | sap sap-id | spoke-sdp sdp-id[:vc-id]}
Context clear>service>id>stp
Description RSTP automatically falls back to STP mode when it receives an STP BPDU. The clear detected-
protocols command forces the system to revert to the default RSTP mode on the SAP or spoke SDP.
Parameters all — Clears all detected protocol statistics.
sap-id — Clears the specified lease state SAP information. See Common CLI Command Descriptions
on page 1933 for command syntax.
sdp-id — The SDP ID to be cleared.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be cleared.
Values 1 — 4294967295
lease-state
Syntax lease-state [no-dhcp-release]
lease-state ip-address ip-address [no-dhcp-release]
lease-state mac ieee-address no-dhcp-release
lease-state sap sap-id [no-dhcp-release]
lease-state sdp sdp-id:vc-id [no-dhcp-release]
Context clear>service>id>dhcp
Description This command clears DHCP lease state information.
Parameters no-dhcp-release — Specifies that the node will clear the state without sending the DHCP release
message.
ip-address ip-address — Clears the DHCP IP address lease state information. The ip-address portion
of the address command specifies the IP host address that will be used by the IP interface within
the subnet. This address must be unique within the subnet and specified in dotted decimal
notation. Allowed values are IP addresses in the range 1.0.0.0 – 223.255.255.255 (with support
of /31 subnets).
mac ieee-address — Clears DHCP MAC address lease state information. The 48-bit MAC address
for the static ARP in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and
ff are hexadecimal numbers. Allowed values are any non-broadcast, non-multicast MAC and
non-IEEE reserved MAC addresses.
sap sap-id — Clears DHCP SAP lease state information. See Common CLI Command Descriptions
on page 1933 for command syntax.
To Next Page
Loading...
