Alcatel-Lucent 7750 SR - Page 1723

VPLS Debug Commands
7750 SR OS Services Guide Page 1723
mac
Syntax [no] mac ieee-address
Context debug>service>id>host-connectivity-verify
Description This command displays Subscriber Host Connectivity Verification (SHCV) events for a particular
MAC address.
Parameters mac-address — Specifies the 48-bit MAC address for the static ARP in the form aa:bb:cc:dd:ee:ff or
aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and ff are hexadecimal numbers. Allowed values are
any non-broadcast, non-multicast MAC and non-IEEE reserved MAC addresses.
sap
Syntax [no] sap sap-id
Context debug>service>id>host-connectivity-verify
Description This command displays Subscriber Host Connectivity Verification (SHCV) events for a particular
SAP.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 1933 for command syntax.
sap
Syntax [no] sap sap-id
Context debug>service>id
Description This command enables debugging for a particular SAP.
Parameters sap-id — Specifies the SAP ID.
stp
Syntax stp
Context debug>service>id
Description This command enables the context for debugging STP.