Alcatel-Lucent 7750 SR - Page 1722

Show, Clear, Debug Commands
Page 1722 7750 SR OS Services Guide
event-type
Syntax [no] event-type {config-change | svc-oper-status-change | sap-oper-status-change |
sdpbind-oper-status-change}
Context debug>service>id
Description This command enables a particular debugging event type.
The no form of the command disables the event type debugging.
Parameters config-change — Debugs configuration change events.
svc-oper-status-change — Debugs service operational status changes.
sap-oper-status-change — Debugs SAP operational status changes.
sdpbind-oper-status-change — Debugs SDP operational status changes.
host-connectivity-verify
Syntax [no] host-connectivity-verify
Context debug>service>id
Description This command enables Subscriber Host Connectivity Verification (SHCV) debugging.
The no form of the command disables the SHCV debugging.
ip
Syntax [no] ip ip-address
Context debug>service>id>host-connectivity-verify
Description This command displays Subscriber Host Connectivity Verification (SHCV) events for a particular IP
address.
Parameters ip-address — The IP address of the IP interface. The ip-address portion of the address command
specifies the IP host address that will be used by the IP interface within the subnet. This address
must be unique within the subnet and specified in dotted decimal notation. Allowed values are IP
addresses in the range 1.0.0.0 – 223.255.255.255 (with support of /31 subnets).