Alcatel-Lucent 7750 SR - Page 1762

Show, Clear, Debug Commands
Page 1762 7750 SR OS Services Guide
Values ipv4-address: a.b.c.d (host bits must be 0)
ipv6-address: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]
ip-int-name — Specifies the IP interface name for which to display information.
Values 32 characters maximum
family — Displays the router IP interface table to display.
Values ipv4 — Displays only those peers that have the IPv4 family enabled.
ipv6 — Displays the peers that are IPv6-capable.
interface-type — Specifies to display either group or subscriber interfaces.
Values group, subscriber
detail — Displays detailed IP interface information.
Default IP interface summary output.
Output Show Service-ID — The following table describes show service-id output fields.
Label Description
If Name
The name used to refer to the IES interface.
Type
Specifies the interface type.
IP-Address
Specifies the IP address/IP subnet/broadcast address of the interface.
Adm
The administrative state of the interface.
Opr
The operational state of the interface.
Admin State
The administrative state of the interface.
Oper State
The operational state of the interface.
IP Addr/mask
Specifies the IP address/IP subnet/broadcast address of the interface.
If Index
The index corresponding to this IES interface. The primary index is 1;
all IES interfaces are defined in the base virtual router context.
If Type
Specifies the interface type.
SAP Id
Specifies the SAP’s port ID.
SNTP B.Cast
Specifies whether SNTP broadcast client mode is enabled or disabled.
Arp Timeout
Specifies the timeout for an ARP entry learned on the interface.
MAC Address
Specifies the 48-bit IEEE 802.3 MAC address.
ICMP Mask Reply
Specifies whether ICMP mask reply is enabled or disabled.