Show, Clear, Debug Commands
Page 1780 7750 SR OS Services Guide
Values ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x [0 — FFFF]H
d [0 — 255]D
prefix-length 1 — 128
mac ieee-address — Specifies the 48-bit MAC address for the static ARP in the form
aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and ff are hexadecimal numbers.
Allowed values are any non-broadcast, non-multicast MAC and non-IEEE reserved MAC
addresses.
statistics
Syntax statistics [ip-int-name | ipv6-address]
Context clear>router>dhcp6
Description This command clears DHCP6 statistics.
Parameters ip-int-name — Specifies the IP interface name up to 32 characters inlength.
ip-address ipv6-address/prefix-length — The IP address of the IP interface. The ip-address portion of
the address command specifies the IP host address that will be used by the IP interface within
the subnet. This address must be unique within the subnet and specified in dotted decimal
notation. Allowed values are IP addresses in the range 1.0.0.0 – 223.255.255.255 (with support
of /31 subnets).
Values ipv6-address x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x [0 — FFFF]H
d [0 — 255]D
prefix-length 1 — 128
statistics
Syntax statistics [sap sap-id | sdp sdp-id:vc-id | interface ip-address | ip-int-name]
Context clear>service>id>dhcp
Description This command clears DHCP statistics.
Parameters sap sap-id — Clears the specified SAP information. See Common CLI Command Descriptions on
page 1933 for command syntax.
sdp sdp-id — The specified SDP to be cleared.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be cleared.
Values 1 — 4294967295
interface ip-address — The interface IP address.
To Next Page
Loading...
