IES Clear Commands
7750 SR OS Services Guide Page 1779
Syntax stp
Context clear>service>statistics>id
Description Clears all spanning tree statistics for the service ID.
lease-state
Syntax lease-state
lease-state ip-address ip-address
lease-state mac ieee-address
lease-state sap sap-id
lease-state sdp sdp-id:vc-id
Context clear>service>id>dhcp
Description Clears DHCP lease state information for this service.
Parameters ip-address — The IP address of the IP interface. The ip-address portion of the address command
specifies the IP host address that will be used by the IP interface within the subnet. This address
must be unique within the subnet and specified in dotted decimal notation. Allowed values are IP
addresses in the range 1.0.0.0 – 223.255.255.255 (with support of /31 subnets).
ieee-address — Specifies the 48-bit MAC address for the static ARP in the form aa:bb:cc:dd:ee:ff or
aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and ff are hexadecimal numbers. Allowed values are
any non-broadcast, non-multicast MAC and non-IEEE reserved MAC addresses.
sap sap-id — Clears the specified lease state SAP information. See Common CLI Command
Descriptions on page 1933 for command syntax.
sdp-id — The specified SDP to be cleared.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be cleared.
Values 1 — 4294967295
lease-state
Syntax lease-state [ip-address ipv6-address/prefix-length] [mac ieee-address]
Context clear>service>id>dhcp6
Description This command clears DHCPv6 lease state information for this service.
Parameters ip-address ipv6-address/prefix-length — The IP address of the IP interface. The ip-address portion of
the address command specifies the IP host address that will be used by the IP interface within
the subnet. This address must be unique within the subnet and specified in dotted decimal
notation. Allowed values are IP addresses in the range 1.0.0.0 – 223.255.255.255 (with support
of /31 subnets).
To Next Page
Loading...
