Show, Clear, Debug Commands
Page 1778 7750 SR OS Services Guide
Parameters all — Clears all FDB entries.
mac ieee-address — Clears only FDB entries in the FDB table with the specified 48-bit MAC
address. The MAC address can be expressed in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff
where aa, bb, cc, dd, ee and ff are hexadecimal numbers.
sap sap-id — Clears the specified SAP information. See Common CLI Command Descriptions on
page 1933 for command syntax.
mesh-sdp — Clears only service FDB entries associated with the specified mesh SDP ID. For a mesh
SDP, the VC ID is optional.
spoke-sdp — Clears only service FDB entries associated with the specified spoke SDP ID. For a
spoke SDP, the VC ID must be specified.
sdp-id — The SDP ID for which to clear associated FDB entries.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID for which to clear associated FDB entries.
Default For mesh SDPs only, all VC IDs.
Values 1 — 4294967295
site
Syntax site service-id
Context clear>service>id
Description This command clears site-specific information for the service.
Parameters service-id — Specifies the service ID or service name up to 64 characters in length.
Values 1 — 2147483648
spoke-sdp
Syntax
spoke-sdp sdp-id:vc-id ingress-vc-label
Context clear>service>id
Description Clears and resets the spoke SDP bindings for the service.
Parameters sdp-id — The spoke SDP ID to be reset.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be reset.
Values 1 — 4294967295
stp
To Next Page
Loading...
