Show, Clear, Debug Commands
Page 1818 7750 SR OS Services Guide
Sample Output
*A:ALA-12# show service id 1 base
===============================================================================
Service Basic Information
===============================================================================
Service Id : 1 Vpn Id : 0
Service Type : VPRN
Customer Id : 1
Last Status Change: 02/01/2007 09:11:39
Last Mgmt Change : 02/01/2007 09:11:46
Admin State : Up Oper State : Down
Route Dist. : 10001:1
AS Number : 10000 Router Id : 10.10.10.103
ECMP : Enabled ECMP Max Routes : 8
Max Routes : No Limit Auto Bind : LDP
Description
Generic information about the service.
Customer Id
The customer identifier.
Last Mgmt Change
The date and time of the most recent management-initiated change to
this customer.
Adm
The desired state of the service.
Oper
The operating state of the service.
Mtu
The largest frame size (in octets) that the service can handle.
Def. Mesh VC Id
This object is only valid in services that accept mesh SDP bindings. It is
used to validate the VC ID portion of each mesh SDP binding defined
in the service.
SAP Count
The number of SAPs defined on the service.
SDP Bind Count
The number of SDPs bound to the service.
Identifier
Specifies the service access (SAP) and destination (SDP) points.
Type
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
AdmMTU
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end ESR, without requiring the
packet to be fragmented.
OprMTU
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end ESR, without requiring the
packet to be fragmented.
Opr
The operating state of the SDP.
Label Description
To Next Page
Loading...
