VPRN Clear Commands
7750 SR OS Services Guide Page 1895
lease-state mac ieee-address
lease-state sap sap-id
lease-state sdp sdp-id:vc-id
Context clear>service>id>dhcp
Description Clears DHCP lease state information for this service.
Parameters ip-address — The IP address of the IP interface. The ip-address portion of the address command
specifies the IP host address that will be used by the IP interface within the subnet. This address
must be unique within the subnet and specified in dotted decimal notation. Allowed values are IP
addresses in the range 1.0.0.0 – 223.255.255.255 (with support of /31 subnets).
ieee-address — Specifies the 48-bit MAC address for the static ARP in the form aa:bb:cc:dd:ee:ff or
aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and ff are hexadecimal numbers. Allowed values are
any non-broadcast, non-multicast MAC and non-IEEE reserved MAC addresses.
sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 1933 for command syntax.
sdp-id — The SDP ID to be cleared.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be cleared.
Values 1 — 4294967295
site
Syntax site service-id
Context clear>service>id
Description This command clears site-specific information for the service.
Parameters service-id — Specifies the service ID or service name up to 64 characters in length.
Values 1 — 2147483648
spoke-sdp
Syntax spoke-sdp sdp-id:vc-id ingress-vc-label
Context clear>service>id
Description This command clears and resets the spoke SDP bindings for the service.
Parameters sdp-id — The spoke SDP ID to be reset.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be reset.
Values 1 — 4294967295
To Next Page
Loading...
