Alcatel-Lucent 7750 SR - Page 1898

Show, Clear, Debug Commands
Page 1898 7750 SR OS Services Guide
no mode
Context debug>service>id>dhcp
Description This command configures the DHCP tracing mode.
The no form of the command disables debugging.
host-connectivity-verify
Syntax [no] host-connectivity-verify
Context debug>service>id
Description This command enables Subscriber Host Connectivity Verification (SHCV) debugging.
The no form of the command disables the SHCV debugging.
ip
Syntax [no] ip ip-address
Context debug>service>id>host-connectivity-verify
Description This command displays Subscriber Host Connectivity Verification (SHCV) events for a particular IP
address.
Parameters ip-address — The IP address of the IP interface. The ip-address portion of the address command
specifies the IP host address that will be used by the IP interface within the subnet. This address
must be unique within the subnet and specified in dotted decimal notation. Allowed values are IP
addresses in the range 1.0.0.0 – 223.255.255.255 (with support of /31 subnets).
mac
Syntax [no] mac ieee-address
Context debug>service>id>host-connectivity-verify
Description This command displays Subscriber Host Connectivity Verification (SHCV) events for a particular
MAC address.
Parameters mac-address — Specifies the 48-bit MAC address for the static ARP in the form aa:bb:cc:dd:ee:ff or
aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and ff are hexadecimal numbers. Allowed values are
any non-broadcast, non-multicast MAC and non-IEEE reserved MAC addresses.
sap