Alcatel-Lucent 7750 SR - Page 1908

Show, Clear, Debug Commands
Page 1908 7750 SR OS Services Guide
-------------------------------------------------------------------------------
6 2:6 Spok 6300 6298
1000 2:1000 Spok n/a 7000
-------------------------------------------------------------------------------
Number of Bindings Found : 2
===============================================================================
*A:ALA-48#
ingress-label
Syntax ingress-label start-label [end-label]
Context show>service
Description This command displays services using the range of ingress labels. If only the mandatory start-label
parameter is specified, only services using the specified label are displayed.
If both start-label and end-label parameters are specified, the services using the range of labels X
where start-label <= X <= end-label are displayed.
Use the show router vprn-service-id ldp bindings command to display dynamic labels.
Parameters start-label — The starting ingress label value for which to display services using the label range. If
only start-label is specified, services only using start-label are displayed.
Values 0, 2048 — 131071
end-label — The ending ingress label value for which to display services using the label range.
Default The start-label value.
Values 2049 — 131071
Output Show Service Ingress-Label — The following table describes show service ingress-label output
fields:
Sample Output
*A:ALA-48# show service ingress-label 2500 15000
===============================================================================
Label Description
Svc Id
The ID that identifies a service.
Sdp I
The ID that identifies an SDP.
Type
Indicates whether the SDP binding is a spoke or a mesh.
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
E. Lbl
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
Number of bindings
found
The total number of SDP bindings that exist within the specified egress
label range.