Alcatel-Lucent 7750 SR - Page 1909

7750 SR OS Services Guide Page 1909
Martini Service Labels
===============================================================================
Svc Id Sdp Binding Type I.Lbl E.Lbl
-------------------------------------------------------------------------------
6 2:6 Spok 6300 6298
88 3:3 Spok 10000 0
-------------------------------------------------------------------------------
Number of Bindings Found : 2
-------------------------------------------------------------------------------
===============================================================================
*A:ALA-48#
sap-using
Syntax sap-using [sap sap-id]
sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
sap-using [ingress | egress] qos-policy qos-policy-id
sap-using encap-type encap-type
Context show>service
Description This command displays specified SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
Parameters ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
qos-policy qos-policy-id — The ingress or egress QoS Policy ID for which to display matching
SAPs.
Values 1 — 65535
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
Values 1 — 65535
sap sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 1933 for command syntax.
ip-addr — The IP address of the interface for which to display matching SAPs.
Values 1.0.0.0 — 223.255.255.255
ip-int-name — The IP interface name for which to display matching SAPs.
encap-type encap-type — Displays the CEM encapsulation type.
Values cem
Output Show Service SAP — The following table describes show service SAP output fields:
Label Description
Port ID
The ID of the access port where the SAP is defined.