Alcatel-Lucent 7750 SR - Page 1910

Show, Clear, Debug Commands
Page 1910 7750 SR OS Services Guide
Sample Output
*A:ALA-48# show service sap-using sap 1/1/21:0
===============================================================================
Service Access Points Using Port 1/1/21:0
===============================================================================
PortId SvcId Ing. Ing. Egr. Egr. Anti Adm Opr
QoS Fltr QoS Fltr Spoof
-------------------------------------------------------------------------------
1/1/21:0 1 1 none 1 none none Up Down
-------------------------------------------------------------------------------
Number of SAPs : 1
===============================================================================
*A:ALA-48#
*A:sim213# show service sap-using encap-type cem
=============================================================================
Service Access Points Using Encap Type 'cem'
=============================================================================
PortId SvcId Adm Opr Alarm
-----------------------------------------------------------------------------
1/5/1.1.1.1 100 Up Up No
1/5/1.2.1.1 200 Up Up No
1/5/1.2.2.1 200 Up Up No
1/5/1.1.3.1 210 Up Up No
1/5/1.1.2.1 220 Up Down No
1/5/1.3.4.1 300 Up Up No
1/5/1.3.6.1 300 Up Up No
1/5/1.2.3.1 400 Up Up No
1/5/1.3.1.1 500 Up Up No
1/5/1.3.2.1 500 Up Up No
1/5/1.1.1.7 501 Up Up No
1/5/1.3.1.2 10100 Up Down No
-----------------------------------------------------------------------------
Number of SAPS : 12
-----------------------------------------------------------------------------
*A:sim213#
Svc ID
The service identifier.
Sap MTU
The SAP MTU value.
I.QoS
The SAP ingress QoS policy number specified on the ingress SAP.
I.MAC/IP
The MAC or IP filter policy ID applied to the ingress SAP.
E.QoS
The SAP egress QoS policy number specified on the egress SAP.
E.Mac/IP
The MAC or IP filter policy ID applied to the egress SAP
A.Pol
The accounting policy ID assigned to the SAP.
Adm
The administrative state of the SAP.
Opr
The operational state of the SAP.
Alarm
Specifies if alarms are enabled.
Label Description (Continued)