7750 SR OS Services Guide Page 1927
sap
Syntax sap sap-id [detail]
Context show>service>id
Description This command displays information for the SAPs associated with the service. If no optional parame-
ters are specified, a summary of all associated SAPs is displayed.
Parameters sap-id — The ID that displays SAPs for the service. See Common CLI Command Descriptions on
page 1933 for command syntax.
interface interface-name — Displays information for the specified IP interface.
ip-address ip-address — Displays information associated with the specified IP address.
detail — Displays detailed information.
wholesaler service-id — The VPRN service ID of the wholesaler. When specified in this context,
SAP, SDP, interface, IP address and MAC parameters are ignored.
Values 1 — 2147483648
detail — Displays detailed information for the SAP.
Output Show Service-ID SAP — The following table describes show service SAP fields:
E. Lbl
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
Label Description (Continued)
Label Description
Service Id
The service identifier.
SAP
The SAP and qtag.
Encap
The encapsulation type of the SAP.
Ethertype
Specifies an Ethernet type II Ethertype value.
Admin State
The administrative state of the SAP.
Oper State
The operating state of the SAP.
Flags
Specifies the conditions that affect the operating status of this SAP.
Display output includes: ServiceAdminDown, SapAdminDown, Inter-
faceAdminDown, PortOperDown, PortMTUTooSmall, L2OperDown,
SapIngressQoSMismatch, SapEgressQoSMismatch,RelearnLimitEx-
ceeded, RxProtSrcMac, ParentIfAdminDown, NoSapIpipeCeIpAddr,
TodResourceUnavail, TodMssResourceUnavail, SapParamMismatch,
CemSapNoEcidOrMacAddr, StandByForMcRing, ServiceMTUTooS-
mall, SapIngressNamedPoolMismatch, SapEgressNamedPoolMis-
match, NoSapEpipeRingNode.
To Next Page
Loading...
