Alcatel-Lucent 7750 SR - Page 1926

Show, Clear, Debug Commands
Page 1926 7750 SR OS Services Guide
endpoint
Syntax endpoint [endpoint-name]
Context show>service>id
Description This command displays service endpoint information.
Parameters endpoint-name — Specifies the name of an existing endpoint for the service.
labels
Syntax labels
Context show>service>id
Description Displays the labels being used by the service.
Output Show Service-ID Labels — The following table describes show service-id labels output fields:
SDP Bind Count
The number of SDPs bound to the service.
Identifier
Specifies the service access (SAP) and destination (SDP) points.
Type
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
AdmMTU
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end ESR, without requiring the
packet to be fragmented.
OprMTU
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end ESR, without requiring the
packet to be fragmented.
Opr
The operating state of the SDP.
Label Description (Continued)
Label Description
Svc Id
The service identifier.
Sdp Id
The SDP identifier.
Type
Indicates whether the SDP is a spoke or a mesh.
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.