VLL Service Configuration Commands
Page 338 7750 SR OS Services Guide
Parameters tod-suite-name — Specifies collection of policies (ACLs, QoS) including time-ranges that define the
full or partial behavior of a SAP. The suite can be applied to more than one SAP.
use-broadcast-mac
Syntax [no] use-broadcast-mac
Context config>service>ipipe>sap
Description This command enables the user of a of broadcast MAC on SAP.
An Ipipe VLL service with the ce-address-discovery command enabled forwards unicast IP packets
using the broadcast MAC address until the ARP cache is populated with a valid entry for the CE IP
and MAC addresses.
The no form of this command enables the user of a of broadcast MAC on SAP.
Default no use-broadcast-mac
mac
Syntax [no] mac ieee-address
Context config>service>ipipe>sap
Description This command assigns a specific MAC address to an Ipipe SAP.
The no form of this command returns the MAC address of the SAP to the default value.
Default The physical MAC address associated with the Ethernet interface where the SAP is configured.
Parameters ieee-address — Specifies the 48-bit MAC address in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff
where aa, bb, cc, dd, ee, and ff are hexadecimal numbers.
mac-refresh
Syntax mac-refresh refresh interval
no mac-refresh
Context config>service>ipipe>sap
Description This command specifies the interval between ARP requests sent on this Ipipe SAP. When the SAP is
first enabled, an ARP request will be sent to the attached CE device and the received MAC address
will be used in addressing unicast traffic to the CE. Although this MAC address will not expire while
the Ipipe SAP is enabled and operational, it is verified by sending periodic ARP requests at the
specified interval.
The no form of this command restores mac-refresh to the default value.
Default 14400
To Next Page
Loading...
