VLL Service Configuration Commands
Page 346 7750 SR OS Services Guide
report-alarm
Syntax [no] report-alarm [stray] [malformed] [pktloss] [overrun] [underrun] [rpktloss] [rfault]
[rrdi]
Context config>service>epipe>sap>cem
Description This command indicates the type of CEM SAP alarm.
The no form of the command removes the parameter from the configuration.
Default On: stray, malformed, pktloss and overrun
Off: rpktloss, rfault, rrdi
Parameters stray — Reports the reception of packets not destined for this CES circuit.
malformed — Reports the reception of packet not properly formatted as CES packets.
pktloss — Reports the lack of reception of CES packets.
overrun — Reports reports the reception of too many CES packets resulting in a overrun of the
receive jitter buffer.
underrun — Reportsreports the reception of too few CES packets resulting in a overrun of the
receive jitter buffer.
rpktloss — Reports hat the remote peer is currently in packet loss status.
rfault — Reports that the remote TDM interface is currently not in service.
rrdi — Reports that the remote TDM interface is currently in RDI status.
rtp-header
Syntax [no] rtp-header
Context config>service>epipe>sap>cem
config>service>cpipe>sap>cem
Description This command specifies whether an RTP header is used when packets are transmitted to the packet
service network (PSN) by the CEM SAP. This mode must be enabled for differential-timed DS1/E1s.
It can optionally be enabled for other DS1/E1s for interoperability purposes.
Default no rtp-header
To Next Page
Loading...
