Virtual Private LAN Services
7750 SR OS Services Guide Page 625
block-on-mesh-failure
Syntax [no] block-on-mesh-failure
Context config>service>vpls>spoke-sdp
config>service>vpls>endpoint
Description This command enables blocking (brings the entity to an opererationally down state) after all
configured SDPs or endpoints are in opererationally down state. This event is signalled to
corresponding T-LDP peer by withdrawing service label (status-bit-signaling non-capable peer) or by
setting “PW not forwarding” status bit in T-LDP message (status-bit-signaling capable peer).
Default disabled
bpdu-translation
Syntax bpdu-translation {auto | pvst | stp}
no bpdu-translation
Context config>service>vpls>spoke-sdp
config>service>vpls>sap
Description This command enables the translation of BPDUs to a given format, meaning that all BPDUs
transmitted on a given SAP or spoke SDP will have a specified format.
The no form of this command reverts to the default setting.
Default no bpdu-translation
Parameters auto — Specifies that appropriate format will be detected automatically, based on type of bpdus
received on such port.
pvst — Specifies the BPDU-format as PVST. Note that the correct VLAN tag is included in the
payload (depending on encapsulation value of outgoing SAP).
stp — Specifies the BPDU-format as STP.
calling-station-id
Syntax calling-station-id {mac | remote-id | sap-id | sap-string}
no calling-station-id
Context config>service>vpls>sap
Description This command enables the inclusion of the calling-station-id attribute in RADIUS authentication
requests and RADIUS accounting messages.
Default no calling-station-id
Parameters mac — Specifies that the mac-address will be sent.
remote-id — Specifies that the remote-id will be sent.
To Next Page
Loading...
