Alcatel-Lucent 7750 SR - Page 638

Virtual Private LAN Services
Page 638 7750 SR OS Services Guide
cumulative-factor
Syntax cumulative-factor cumulative-factor
no cumulative-factor
Context configure->service->vpls->mac-move->primary-ports
configure->service->vpls->mac-move->secondary-ports
Description This command configures a factor for the primary or secondary ports defining how many MAC
relearn periods should be used to measure the MAC relearn rate . This rate must be exceeded during
consecutive periods before the corresponding ports (SAP and/or spoke-SDP) are blocked by the
MAC-move feature.
Parameters cumulative-factor — Specifies a MAC relearn period to be used for MAC relearn rate.
Values 3 — 10
sap
Syntax [no] sap sap-id
Context config>service>vpls>mac-move>primary-ports
config>service>vpls>mac-move>secondary-ports
Description This command declares a given SAP as a primary (or secondary) VPLS port.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 1933 for command syntax.
spoke-sdp
Syntax [no] spoke-sdp spoke-id
Context config>service>vpls>mac-move>primary-ports
config>service>vpls>mac-move>seocndary-ports
Description This command declares a given spoke SDP as a primary (or secondary) VPLS port.
Parameters spoke-id — Specifies the SDP ID to configure as the primary VPLS port.
Values 1 — 17407
vc-id — The virtual circuit identifier.
Values 1 — 4294967295
cumulative-factor
Syntax [no] cumulative-factor factor
Context config>service>vpls>mac-move>primary-ports