Virtual Private LAN Services
Page 718 7750 SR OS Services Guide
SAP Subscriber Management Commands
cpu-protection
Syntax cpu-protection policy-id [mac-monitoring]
no cpu-protection
Context config>service>vpls>sap
Description This command assigns an existing CPU protection policy to the associated service SAP. The CPU
protection policies are configured in the config>sys>security>cpu-protection>policy cpu-
protection-policy-id context.
If no CPU protection policy is assigned to a service SAP, then a the default policy is used to limit the
overall-rate. The default policy is policy number 1 and can be viewed in the
show>system>security>cpu-protection>policy 1 command output.
Parameters policy-id — Specifies an existing CPU protection policy.
Values 1 — 255
mac-monitoring — When specified, the per MAC rate limiting should be performed, using the per-
source-rate from the associated cpu-protection policy.
default-msap-policy
Syntax default-msap-policy policy-name
no default-msap-policy
Context config>service>vpls>sap
Description This command specifies an existing managed SAP policy. Managed SAPs allow the use of policies
and a SAP template for the creation of a SAP. Managed SAP policies are created in the
config>subscr-mgmt context. This command is only applicable to SAPs created as a capture-sap.
Default none
Parameters msap-policy-name — Specifies an existing managed SAP policy name up to 32 characters in length.
sub-sla-mgmt
Syntax [no] sub-sla-mgmt
Context config>service>vpls>sap
Description This command enables the context to configure subscriber management parameters for this SAP.
Default no sub-sla-mgmt
To Next Page
Loading...
