Virtual Private LAN Services
7750 SR OS Services Guide Page 747
interleave
Syntax interleave
no interleave
Context config>service>vpls>sap>frame-relay>frf.12
Description This command enables interleaving of high priority frames and low-priority frame fragments within a
FR SAP using FRF.12 end-to-end fragmentation.
When this option is enabled, only frames of the FR SAP non expedited forwarding class queues are
subject to fragmentation. The frames of the FR SAP expedited queues are interleaved, with no
fragmentation header, among the fragmented frames. In effect, this provides a behavior like in
MLPPP Link Fragment Interleaving (LFI).
When this option is disabled, frames of all the FR SAP forwarding class queues are subject to
fragmentation. The fragmentation header is however not included when the frame size is smaller than
the user configured fragmentation size. In this mode, the SAP transmits all fragments of a frame
before sending the next full or fragmented frame.
The receive direction of the FR SAP supports both modes of operation concurrently, with and without
fragment interleaving.
The no form of this command restores the default mode of operation.
Default no interleave
scheduling-class
Syntax scheduling-class class-id
no scheduling-class
Context config>service>vpls>sap>frame-relay
Description This command specifies the scheduling class to use for this SAP. This object is only applicable for a
SAP whose bundle type is set to MLFR.
Parameters class-id — Specifies the scheduling class.
Values 0 — 3
host-connectivity-verify
Syntax host-connectivity-verify source-ip ip-address [source-mac ieee-address] [interval
interval] [action {remove | alarm}]
Context config>service>vpls
config>service>vpls>sap
Description This command enables enables subscriber host connectivity verification on a given SAP within a
VPLS service. This tool will periodically scan all known hosts (from dhcp-state) and perform a UC
To Next Page
Loading...
