Page 830 7750 SR OS Services Guide
Values 1 — 2147483647
Default null (0)
m-vpls — Specifies a management VPLS.
b-vpls | i-vpls — Creates a backbone-vpls or ISID-vpls for use with PBB
service-name
Syntax service-name service-name
no service-name
Context config>service>vpls service-id
Description This command configures an optional service name, up to 64 characters in length, which adds a name
identifier to a given service to then use that service name in configuration references as well as
display and use service names in show commands throughout the system. This helps the service
provider/administrator to identify and manage services within the 7750 SR, 7450 ESS and 7710 SR
platforms.
All services are required to assign a service ID to initially create a service. However, either the service
ID or the service name can be used o identify and reference a given service once it is initially created.
Parameters service-name — Specifies a unique service name to identify the service. Service names may not begin
with an integer (0-9).
eth-tunnel
Syntax eth-tunnel tunnel-id
Context config>service>vpls
Description This command associates a BVPLS SAP with the global Ethernet tunnel object specified by tunnel-
id. Only one-to-one mapping between SAP and Ethernet tunnel is supported in the initial
implementation. The global eth-tunnel tunnel-id with at least a member port must be configured in
advance for the command to be successful. A SAP will be instantiated using the active path
components (member port and control-tag) for VPLS forwarding. The last member port in the
Ethernet Tunnel cannot be deleted if there is a SAP configured on that eth-tunnel. This command is
only available in the BVPLS context.
The no form of this command removes the sap from the Ethernet tunnel object.
Default no sap is specified
Parameters tunnel-id — Specifies the value of the Ethernet tunnel identifier to be used for the SAP.
Values 1-64
mrp
To Next Page
Loading...
