VPLS Service Commands
7750 SR OS Services Guide Page 831
Syntax mrp
Context config>service>vpls
config>service>vpls>mesh-sdp
config>service>vpls>sap
config>service>vpls>spoke-sdp
Description This command configures Multiple Registration Protocol (MRP) parameters. MRP is valid only
under B-VPLS.
attribute-table-size
Syntax [no] attribute-table-size value
Context config>service>vpls>mrp
Description This command controls the number of attributes accepted on a per B-VPLS basis. When the limit is
reached, no new attributes will be registered.
If a new lower limit (smaller than the current number of attributes) from a local or dynamic I-VPLS is
being provisioned, a CLI warning will be issued stating that the system is currently beyond the new
limit. The value will be accepted, but any creation of new attributes will be blocked under the
attribute count drops below the new limit; the software will then start enforcing the new limit.
Default maximum number of attributes
Parameters value — [1-2048] for ESS-6/7/12 or SR-7/SR-12
[1-1023] for ESS1/SR1/7710
attribute-table-high-wmark
Syntax [no] attribute-table-high-wmark high-water-mark
Context config>service>vpls>mrp
Description This command specifies the percentage filling level of the MMRP attribute table where logs and traps
are sent.
Default 95%
Parameters high-water-mark — 1%-100%
attribute-table-low-wmark
Syntax [no] attribute-table-low-wmark low-water-mark
Context config>service>vpls>mrp
To Next Page
Loading...
