Page 832 7750 SR OS Services Guide
Description This command specifies the MMRP attribute table low matermark as a percentage. When the
percentage filling level of the MMRP attribute table drops below the configured value, the
corresponding trap is cleared and/or a log entry is added.
Default 90%
Parameters low-water-mark — 1%-100%
flood-time
Syntax flood-time flood-time
no flood-time
Context config>service>vpls>mrp
Description This command configures the amount of time, in seconds, after a status change in the VPLS service
during which traffic is flooded. Once that time expires, traffic will be delivered according to the
MMRP registrations that exist in the VPLS. When “no flood-time” is executed, flooding behavior is
disabled.
Default no flood-time
Parameters flood-time — Specifies the MRP flood time, in seconds.
Values 3 — 600
join-time
Syntax [no] join-time value
Context config>service>vpls>sap>mrp
config>service>vpls>spoke-sdp>mrp
config>service>vpls>mesh-sdp>mrp
Description This command controls the interval between trasmit opportunities that are applied to the Applicant
state machine. An instance of this Join Period Timer is required on a per-Port, per-MRP Participant
basis. For additional information, refer to IEEE 802.1ak-2007 section 10.7.4.1.
Default 2
Parameters value — [1-10] tenths of a second
leave-time
Syntax [no] leave-time value
Context config>service>vpls>sap>mrp
config>service>vpls>spoke-sdp>mrp
config>service>vpls>mesh-sdp>mrp
To Next Page
Loading...
