IES Service Configuration Commands
7750 SR OS Services Guide Page 949
other-stateful-configuration
Syntax [no] other-stateful-configuration
Context config>service>ies>sub-if>grp-if>ipv6>router-ad
Description This command sets the "other configuration" flag. This flag indicates that DHCPv6 is available for
autoconfiguration of other (non-address) information such as DNS-related information or information
on other servers in the network. See RFC 3736, Stateless Dynamic Host Configuration Protocol
(DHCP) for IPv6.
Default no other-stateful-configuration
prefix-options
Syntax [no] prefix-options
Context config>service>ies>sub-if>grp-if>ipv6>router-ad
Description This command configures Router Advertisement parameters for IPv6 prefixes returned via RADIUS
Framed-IPv6-Prefix. All prefixes will inherit these configuration parameters.
Default no prefix-options
autonomous
Syntax [no] autonomous
Context config>service>ies>sub-if>grp-if>ipv6>router-ad>prefix-op
Description This command specifies whether the prefix can be used for stateless address configuration.
Default no autonomous
preferred-lifetime
Syntax preferred-lifetime [seconds | infinite]
no preferred-lifetime
Context config>service>ies>sub-if>grp-if>ipv6>router-ad>prefix-op
Description This command configures the remaining length of time in seconds that this prefix will continue to be
preferred, for example, time until deprecation. The address generated from a deprecated prefix should
not be used as a source address in new communications, but packets received on such an interface are
processed as expected.
Default 3600
Parameters seconds — Specifies a decimal time interval in seconds.
To Next Page
Loading...
