IES Interface Commands
Page 960 7750 SR OS Services Guide
Default no proxy-arp
Parameters policy-name — The export route policy name. Allowed values are any string up to 32 characters long
composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes. The specified name(s) must
already be defined.
remote-proxy-arp
Context config>service>ies>interface
config>service>ies>sub-if>grp-if
Description This command enables remote proxy ARP on the interface.
Remote proxy ARP is similar to proxy ARP. It allows the router to answer an ARP request on an
interface for a subnet that is not provisioned on that interface. This allows the router to forward to the
other subnet on behalf of the requester. To distinguish remote proxy ARP from local proxy ARP,
local proxy ARP performs a similar function but only when the requested IP is on the receiving
interface.
Default no remote-proxy-arp
ipv6
Syntax [no] ipv6
Context config>services>ies>sub-if
Description This command enables IPv6 forwarding on the specified subscriber-interface.
Default no ipv6
subscriber-prefixes
Syntax [no] subscriber-prefixes
Context config>services>ies>sub-if>ipv6
Description This command specifies aggregate off-link subscriber prefixes associated with this subscriber
interface. Individual prefixes are specified under the prefix context list aggregate routes in which the
next-hop is indirect via the subscriber interface.
prefix
Syntax prefix ipv6-address/prefix-length [pd] [wan-host]
no prefix ipv6-address/prefix-length
Context config>services>ies>sub-if>ipv6>sub-prefixes
To Next Page
Loading...
