IES Interface Commands
Page 988 7750 SR OS Services Guide
number — Specifies the number of destination unreachable ICMPv6 messages are issued in the time
frame specified by the seconds parameter.
Values 10 — 1000
Default 100
seconds — Specifies the time frame in seconds that is used to limit the number of destination
unreachable ICMPv6 messages to be issued.
Values 1 — 60
Default 10
local-proxy-nd
Syntax [no] local-proxy-nd
Context config>service>ies>if>ipv6
Description This command enables local proxy neighbor discovery on the interface.
The no form of the command disables local proxy neighbor discovery.
proxy-nd-policy
Syntax proxy-nd-policy policy-name [policy-name...(up to 5 max)]
no proxy-nd-policy
Context config>service>ies>if>ipv6
Description This command applies a proxy neighbor discovery policy for the interface.
Parameters policy-name — Specifies an existing neighbor discovery policy name. Allowed values are any string
up to 32 characters long composed of printable, 7-bit ASCII characters. If the string contains
special characters (#, $, spaces, etc.), the entire string must be enclosed within double quotes.
The specified policy name(s) must already be defined.
neighbor
Syntax neighbor ipv6-address mac-address
no neighbor ipv6-address
Context config>service>ies>if>ipv6
Description This command configures IPv6-to-MAC address mapping on the IES interface.
Default none
Parameters ipv6-address — The IPv6 address of the interface for which to display information.
To Next Page
Loading...
