Alesis Fusion Reference Manual

3
Chapter 3: Fusion Modes
98
Menu: Program/Synth/LFO
Parameter: Rate (Only available when Sync is set to “None”)
Value Range: 0.0200 Hz – 200 Hz
Sets the speed of the LFO. The higher the value, the faster the LFO will
oscillate every second.
Menu: Program/Synth/LFO
Parameter: Phase (Unavailable when Type is set to “Random”)
Value Range: -100% (-180 Degrees) to +99% (178 Degrees),
Random
Shifts your waveform to the right (or left) allowing you to start your
oscillator on an offset. Setting this parameter to “Random” causes your
LFO to begin at a random point in its cycle.
Menu: S Program/Synth/LFO
Parameter: Ramp
Value Range: 0 – 30 Sec
Sets the amount of time it takes your LFO to gradually “fade in” from
zero to the maximum amount of modulation. If you set this value to 0,
then the LFO starts immediately.
Menu: Program/Synth/LFO
Parameter: Del LFO
Value Range: Yes, No
This button deletes the currently selected Envelope. A dialog box will
appear asking you to confirm whether you want to delete your LFO.
Press “Yes” to delete.

Alesis Fusion Specifications

General

Type	Workstation
Polyphony	64 voices
Synthesis Types	Sample Playback, Virtual Analog, FM, Physical Modeling
Display	240 x 128 pixel LCD
MIDI	In, Out, Thru
RAM	64MB (expandable to 192MB)
Weight (61-key)	28 lbs
Keyboard	61 or 88 keys
Keyboard Type	Semi-weighted (61-key), Hammer action (88-key)
Effects	Reverb, Chorus, Delay, Flanger, Phaser, Distortion, EQ
Storage	40GB internal hard drive
Sampling	Yes
Inputs	2 x 1/4" inputs, 1 x XLR
Outputs	4 x 1/4" outputs, 1 x Headphone