Chapter 3: Fusion Modes
3
157
Note: This page will look different depending on what you select for the “Process”
parameter (see below).
Menu: Song/Editor/Tracks/Process
Parameter: Process
Value Range: Clear, Crop, Cut, Copy, Paste Over, Paste Mix, Slide, Adjust
Note Gate, Adjust Note Velocity, Note Transpose, Note Quantize, Audio
Gain, Audio Fade
(Note: This parameter MUST be set to “Adjust Note Gate” for the
correct parameters to be displayed on the remainder of the page. If your
page looks different than the one displayed above, it is probably because
this parameter is not set to “Adjust Note Gate.”)
The “Adjust Note Gate” setting allows you to change the length of the notes on your
selected track.
Menu: Song/Editor/Tracks/Process
Parameter: Edit Start
Value Range: (varies)
This parameter sets the point at which your edits will start to take place.
Menu: Song/Editor/Tracks/Process
Parameter: Edit End
Value Range: (varies)
This parameter sets the end point after which your track will not be affected.
Menu: Song/Editor/Tracks/Process
Parameter: Adjust Gate
Value Range: 1-200%
This parameter lets you adjust the length of the notes on your track. For example, a
setting of 5% will cause all the notes within your “Edit Start” and “Edit End” points
to be reduced to 5% of their original length. A setting of 100% will result in no
changes. A setting of 200% will double the length of each note.
Menu: Song/Editor/Tracks/Process
Parameter: Execute
Value Range: (none)
This button executes the current process you’ve selected.
To Next Page
Loading...
Need help?
General
