Chapter 3: Fusion Modes
3
207
Menu: Global/Item/Process
Parameter: Rename (Only available for bank and item selections,
but not volume folders)
Value Range: (none)
This button brings up a prompt allowing you to rename your item or
bank selection.
Menu: Global/Item/Process
Parameter: Move (Only available for item selections, but not
volume folders or banks)
Value Range: (none)
This button brings up a page allowing you to move your item selection to
another destination.
Menu: Global/Item/Process
Parameter: Delete (Only available for bank and item selections,
but not volume folders)
Value Range: (none)
This button brings up a prompt allowing you to delete bank and item
selections. Use this option with caution as you will not be able to undo
this action.
Menu: Global/Item/Process
Parameter: Verify (Only available for volume folders and banks, but
not items)
Value Range: (none)
This button analyzes and verifies that all of the items contained within
the currently selected bank exist and removes all items that do not exist.
It will also add items to the bank that exist in the folder but not in the
bank list. End users will usually not need to be worried about this unless
they add, delete, or move files contained on the Fusion using the USB
connection. Doing this may cause the Fusion’s bank list to become “out
of sync” with whatever is actually contained in the Fusion and the bank
list will need to be resynched using the Verify command. If you add a
program to a bank directory using USB, this command will allow you to
actually see the program that you have added.
To Next Page
Loading...
Need help?
General
