Chapter 3: Fusion Modes
3
53
The Synth/Osc/Config screen provides a convenient overview showing
how many of the commonly used parameters in the Drum Synthesis
submenus are configured.
This page shows parameter settings of eight consecutive oscillators in
relation to one another. By having these common parameters on one
screen, it saves users from having to jump back and forth between
multiple oscillator pages. You can change oscillator settings (volume,
pan, tuning, etc) by editing the parameters labeled “1:”, “2:”, and so on.
Since our synthesis type is set to Drum Synthesis, we have 64 oscillators
available for editing.
Menu: Program/Synth/Osc/Config
Parameter: View (Left Side; oscillator range)
Value Range: 1 to 64 (displayed in groups of 8)
This menu allows you to cycle through all 64 oscillators that you can use
under the Drum Synthesis method.
Menu: Program/Synth/Osc/Config
Parameter: View (Right Side; Oscillator Parameter)
Value Range: Osc Enable, Osc Note, Osc Coarse Tune, Osc Fine
Tune, Osc Volume, Osc Pan
This section provides quick access to common oscillator parameters.
Choose the parameter that you want to edit across your eight drums.
Note that this selection changes what appears in the 1: through 64: fields
(see below).
Menu: Program/Synth/Osc/Config
Parameter: 1: through 64:
Value Range: Varies depending on View setting (see above)
This section provides quick access to common oscillator parameters.
The contents of this parameter change depend on your “view” (Right
Side) settings. Use the Control Wheel to adjust the listed values.