Chapter 3: Fusion Modes
3
175
Menu: Sampler/Zone/Range
Parameter: EDIT Zone
Value Range: (varies depending on number of zones created)
Select the zone you’d like to edit using this parameter.
Menu: Sampler/Zone/Range
Parameter: Low Key
Value Range: C-2 to G8
This parameter sets the lowest note of the range to which the sample in
the zone will respond.
Menu: Sampler/Zone/Range
Parameter: High Key
Value Range: C-2 to G8
This parameter sets the highest note of the range to which the sample in
the zone will respond.
Menu: Sampler/Zone/Range
Parameter: Root Note
Value Range: C-2 to G8, Use sample
This parameter determines what note on the keyboard will play the
sample back at its original pitch. In other words, if you set the root note
to “C3” when you trigger the sample using the C3 key, you will hear it
just as it was recorded. If you press any keys higher than C3 then the
sample will be pitched up. Conversely, if you press any keys lower than
C3 the sample will be pitched down.
The “Use sample” setting uses the root note stored with the sample (see
the sample “Root Note” parameter on page 182 for more).