3
Chapter 3: Fusion Modes
112
Menu: Mix/Part/Output
Parameter: Use Prog Value
Value Range: On, Off
If the program for your currently selected part already has the desired
pan setting, you can use it by checking this box.
Menu: Mix/Part/Output
Parameter: Insert
Value Range: None, 1-4
If you’d like to run your currently selected part through an insert effect,
select which inset effect you’d like to use. The name of the effect
appears in parenthesis next to the word “insert” on screen. If you do
not want to use any insert effects, set this parameter to none.
In most cases you’ll want to route only one part into one insert, but
we’ve programmed the Fusion to allow multiple parts to be routed to the
same insert. This allows for more creative routing options, but keep in
mind that once two parts are routed to the same insert effect they
become summed and cannot be “unsummed” as the output of the insert
effect is routed back to the parts.
Menu: Mix/Part/Output
Parameter: Bus Send 1, Bus Send 2
Value Range: 0-100%
This parameter determines how much of your program output is being
sent to effects busses 1 and 2. A “dry” setting of 0% means that none
of your signal is being sent to the bus effects. A “wet” signal of 100%
means that equal amounts of your original signal and effected signal are
being routed to the output.
Menu: Mix/Part/Output
Parameter: Output Bus
Value Range: Main, Aux, None
Select the output bus of your part here. Set this parameter to “Aux” if
you want the part to be routed out of the Aux outputs, or to “none” if
you do not want the output routed out of the Fusion. Otherwise, leave
this parameter set to “Main” for normal operation.
To Next Page
Loading...
Need help?
General
