4
Chapter 4: Advanced Features
240
Menu: Program/Mod/Edit/Src/Des
Parameter: Source Index
Value Range: Varies depending on the assigned source (see above)
Some of the sources that you select (see above) have a number of
additional options that let you define your source more specifically.
Keytrack – This range can vary from 1 semitone = 100% to 8
octaves+4 semitones = 100%. Keytrack is bi-polar around
middle-C, and you can select the keytracking range in 1
semitone increments. In other words, if you set this parameter
to “1 octave = 100%” the effect of your modulation gradually
reaches 100% as you move up or down one octave from
middle-C.
Controller – The Fusion has a number of different physical
control sources (i.e., buttons, knobs, etc.) that you can select as
your modulation source. Select a specific physical controller
from the following: Mod wheel, Foot Pedal, Switch S1, Switch
S2, Knob Assign 1-4, Trigger T1-T4, Footswitch, Sustain Pedal,
Pitch Wheel, Aftertouch.
Envelope – You can create up to eight envelopes for each
program on the Fusion, and any of those envelopes can serve
as a source for a mod route. Select which envelope you’d like to
use here. Note that the available envelopes will vary depending
on how many envelopes have been created for that program
(i.e., you will not see envelopes 5 though 8 if a program only
uses 4 envelopes).
LFO – You can create up to eight LFOs for each program on
the Fusion, and any of those LFOs can serve as a source for a
mod route. Select which LFO you’d like to use here. Note that
the available LFOs will vary depending on how many LFOs
have been created for that program (i.e., you will not see LFOs
5 though 8 if a program only uses 4 LFOs).
To Next Page
Loading...
Need help?
General
