Chapter 3: Fusion Modes
3
103
Setting Individual Part Parameters
Menu: Mix/Part/General
Parameter: EDIT Part
Value Range: (Varies depending on how many parts have been
created)
Select the part you’d like to edit using this parameter.
Menu: Mix/Part/General
Parameter: Program
Value Range: (Varies depending on what programs are available to
the Fusion)
Select the bank (the top line) and program number (the bottom line) that
you’d like to select for this part. The name of the program is listed in the
large, bold letters in the middle of the screen.
Menu: Mix/Part/General
Parameter: Arp Number
Value Range: None, 1-4
Each mix can have up to four arpeggiation patterns. Select the
arpeggiation pattern you’d like to use for this part. If you do not want to
use an arpeggiation pattern for this part, set this parameter to “None.”
Menu: Mix/Part/General
Parameter: MIDI Channel
Value Range: Global Channel, 1-16
This parameter selects the channel on which your part can be sending
and receiving data. Once you have selected a channel here, you can
decide whether the channel will send and/or respond to MIDI data by
setting the parameters found on the Mix/Part/Controls page (see pg.
109).
This parameter is often used in situations where you are using the Fusion
with an external sequencer. In such cases, you may want to place each
part on a separate channel so that your sequencer can trigger individual
parts.
About “Global Channel
Global Channel is a MIDI channel that is
defined in Global mode. This is useful if you
need to change MIDI channel settings on
many mixes quickly, because you can simply
edit the “Global MIDI Channel” parameter
on the Global/Settings/MIDI page.
Once you change this setting, all mix parts
that have been set to “Global Channel” will
be changed immediately. There is no need
to change every Mix individually.
To Next Page
Loading...
Need help?
General
