3
Chapter 3: Fusion Modes
86
Menu: Program/Utility
Parameter: Split point (only available for “Generate Split Mix”)
Value Range: C-2 to G8
This parameter lets you select at which point the split will take place in
your mix. Note that this parameter is only available when you select
“Generate Split Mix” for the parameter listed above. You can also hold
LOCATE and press the desired split key when the cursor is on this
parameter to select the split point.
Menu: Program/Utility
Parameter: To Song
Value Range: Generate Song, Add to Current Song
This button adds the current program to a song. To add the program to
a new song, select “Generate Song.” To add the program to the song
that is currently loaded in Song mode, select “Add to Current Song.”
Menu: Program/Utility
Parameter: Multi (only available for sample and drum programs)
Value Range: (varies)
This button allows you to select any of your multisamples (from a
sample or drum based program) for further editing in Sampler mode.
Select the oscillator you’d like to edit and press the “Multi” action button
to the right of the screen.
Note that this button is only available if your current program is a
Sample or Drum program (since the other program types do not use
samples).