3
Chapter 3: Fusion Modes
182
Menu: Sampler/Sample/Edit
Parameter: EDIT Zone
Value Range: (varies depending on number of zones created)
Select the zone you’d like to edit using this parameter.
Menu: Sampler/Sample/Edit
Parameter: Root Note
Value Range: C-2 to G8
This parameter determines what note on the keyboard will play back
your sample at its original pitch. In other words, if you set the root note
to “C3” when you trigger the sample using the C3 key, you will hear it
just as it was recorded. If you press any keys higher than C3 then the
sample will be pitched up. Conversely, if you press any keys lower than
C3 the sample will be pitched down.
Menu: Sampler/Sample/Edit
Parameter: Loop Type
Value Range: Normal, Forward-Reverse
This parameter sets how your loop behaves:
Normal: When set to “Normal” the sample
plays from the beginning to the “Loop
End” point and jumps back to the
“Loop Start” position and continues
playing through the file.
Forward-Reverse: When set to “Forward-Reverse” your
loop starts playing from the beginning
to the “Loop End” point and then
plays the sample in reverse until it
reaches the “Loop Start” position. At
the “Loop Start” position sample
playback switches and the sample
plays regularly again.
Why can’t I hear any changes I make?
Note that the parameters you set on the Zone
pages can override the parameters found on
this page. If you find that you are editing the
parameters on this page but are not hearing
the effects of your changes, take a look at the
Sampler/Zone pages. If the parameters on
those pages are set to anything other than
the “Default” values, you will not be able to
hear changes on this page.
To Next Page
Loading...
Need help?
General
